How can I adjust my nitrogen recommendation on the Crop Zone Monitoring tab?
Overview:
After you create a variable rate nitrogen recommendation, you might want to adjust the recommendation because of factors such as changes in the field, weather, or equipment applicators. With the map in the NREC view, use the options in the left panel to adjust the recommended nitrogen. For irrigated crop zones, the adjustments are applied only to the irrigated portion of the field.
Note: Changes made to the nitrogen recommendation on the Crop Zone Monitoring tab are automatically included in exported nitrogen recommendations. You do not need to click Run RX again to include these changes.
Note: Changes to the nitrogen recommendation on this page are saved to a layer in Field360 Studio when you export the prescription.
Requirements:
- Corn crop zone enrolled at the Premium level
- Existing variable-rate nitrogen recommendation (Run RX)
Process:
To adjust the nitrogen by a specified number of pounds:
- Above the map in NREC view, click Multiple Zones and select one or more zones on the map or click Select All.
- In the Multi-Decision Zone Nitrogen Details section on the left, click Adjust N by.
- Enter the lb/ac in 5-pound increments for the selected decision zones.
- Click Apply.
To set the nitrogen to a specified number of pounds per acre:
- Above the map in NREC view, click Multiple Zones and select one or more zones on the map or click Select All.
- In the Multi-Decision Zone Nitrogen Details section on the left, click Adjust N by and select Set N to.
- Enter a value in lbs/ac to set the value for the selected decision zones.
- Click Apply.
To adjust the recommended nitrogen by a percentage:
- Above the map in NREC view, click Multiple Zones and select one or more zones on the map or click Select All.
- In the Multi-Decision Zone Nitrogen Details section on the left, click Adjust N by and select Adjust N by %.
- For %, enter a positive or negative percent amount or click the arrows to select an amount.
- Click Apply.
To limit nitrogen to a minimum and maximum amount:
- Above the map in NREC view, click Multiple Zones and select one or more zones on the map or click Select All.
- In the Multi-Decision Zone Nitrogen Details section on the left, click Adjust N by and select Set N to Min and Max.
- For Min, enter the minimum pounds per acre to apply across the selected decision zones. The default is the lowest amount in the selected zone or zones.
- For Max, enter the maximum pounds per acre to apply across the selected decision zones. The default is the highest amount in the selected zone or zones.
For decision zones where the amount was already between the min and max range, the values remain the same.
- Click Apply.